- All Products are New and from Manufacturer Authorized Retailers
- 30 day return policy
- Free Shipping
No Additional Fees
|Package Weight||0.6 lb|
|Box Dimensions (LxWxH)||8.5 x 6.2 x 2.3"|
|Frequency Response||50 Hz to 20 kHz|
|Maximum Input Level||120 dB SPL (@ 1 kHz with sensitivity set to H and low-cut filter set to FLAT)|
|Output Impedance||1.6 kΩ (RL = 2.2 kΩ, Vcc = 2.5 V )|
|Signal to Noise Ratio||74 dB typical (RL = 2.2 kΩ, Vcc = 2.5 V )|
|Sensitivity||H Setting: −37 dB (1 kHz, 0 dB = 1 V/Pa), (RL = 2.2 kΩ, Vcc = 2.5 V )L Setting: −52 dB (1 kHz, 0 dB = 1 V/Pa), (RL = 2.2 kΩ, Vcc = 2.5 V )|
|Low Cut Filters||130 Hz (RL = 2.2 kΩ, Vcc = 2.5 V )|
|Connector||1/8" (3.5 mm) TRS stereo mini plug (Tip: left channel, Ring: right channel, Sleeve: ground)|
|Power Requirement||Plug-in power (JEITA standard CP-1203A)|
|Operating Temperature Range||41 to 95°F (5 to 35°C)|
|Dimensions (WxHxD)||2.2 x 2.3 x 2.7" (57 x 59 x 69 mm), excluding cable and accessories)|
|Weight||2.6 oz (75.0 g)|
|Cable Length||13" (33 cm)|
Excellent upgrade to my DSLR video over the onboard mic. I've shot some moving water scenes at a river rapid and at the beach. With the onboard mic I just get an unpleasant roaring in mono. With the TM-2X I get the relaxing sounds of waves in stereo.
I'm a photographer that also shoots video! Very happy with the sound quality from the Tascam TM-2X stereo microphone. It produced an excellent recording.A must have for stereo sound recording on DSLRs and mirrorless.Best ambient mic system for cameras.
This is a super little mic that we use on DSLRs or even on the OSMO for quality audio. The only challenge is performing some tests beforehand with the settings on the mic and making audio level adjustments either in the camera or in the DJI app if you're using an OSMO.
Mikrofon Tascam urcite potesi vetsinu tzv. zrcadlovkaru, kteri chteji za priznivou cenu vyrazne zkvalitnit zvuk svych videi, aniz by na to potrebovali vic nez samotne teleso mikrofonu a kabel s tri a pulkou jackem bez nutnosti dalsi baterie.
Small and light weight. Easy to attach to the camera's hot shoe. Simple directions. Sound quality is good.
I use this mic on my 7D Mark II to shoot video of my son playing piano. I like its compactness, ease of use and audio quality. The construction could be better; the mount locknuts on both the mic and the noise isolation arm are built entirely with plastic.
This mic worked very well with my 5D Mark III the audio was clean. What I did was run it through my bechtech mixer so I wouldn't get the hum from the preamps in the DSLR. The overall build of the mic is good accept the cold shoe mount, do not over tighten it will break very easily.
Mechanick zpracovn na velmi dobr rovni, pouze rameno je chatrnj, z plastu. Tot plat o paticch ramene u samotnho mikrofonu, v nich je implementovn i stativov zvit.Po zvukov znmce: vborn prostorovost i frekvenn vyrovnanost od nzkch po vysok frekvence, inn ochrana proti zvukm z otes vzniklch na...
I've only had this microphone a short while. It was a windy day and so I used the provided wind guard. I probably should have used it on low cut, but as it was the audio contained a lot of wind noise. It also picks up af noise from the af motor but not as much as the onboard mic does.
I used the TM-2X to record the Principal Cellist of the Colorado Symphony in a video using my Canon 70D. The sound quality from my previews of the video shoot was very good, better than I expected actually.